Motorcycle Suspension Fork Lock Nuts / Bushes / O-Rings

All rebuildable suspensions need some basic shared parts - fasteners such as locknuts to hold damping pistons to base towers, teflon lined shaft collars or acetal rod bushes to hold sliding tubes concentric without too much friction, tiny mid-speed valve (also called refill or non-return) springs to help tune your shim stack, rubber o-rings to keep oil and gas pressure sealed from each other. Motorbike front fork and rear shock absorbers both need these when servicing or tuning, and here is where you'll find them.

The other shared parts that are found in both forks and shocks are shims & washers - but Teknik have so many that we have created our own Valving Shims section - including complete bulk kits, ring shims, check shims, cup washers and valve stop washers.

If you are a bike workshop or a DIY suspension tuner you should stock up on these essential wear parts - they are in everything and should be replaced every rebuild.