The Tractive X-TREME fork cartridge kit for the Aprilia Tuareg 660 Rally replaces the standard fork internals with a closed, pressurised cartridge design for more consistent damping control in demanding conditions. This version is configured to lower the ride height, helping improve accessibility and confidence at low speeds without changing the overall intent of the bike. As a cartridge-based system, it focuses on maintaining stable hydraulic behaviour across varied terrain.

Who is this for?

  • Tuareg 660 Rally riders who want a more controlled and confidence-inspiring front end on mixed surfaces.
  • Adventure and rally use where front-end stability and repeatability matter over long, rough stages.
  • Riders who specifically want a lowered front ride height for easier footing and balance.

Design & features

  • Closed, pressurised cartridge architecture to help reduce cavitation and maintain damping consistency during sustained use.
  • Cartridge kit format designed to replace internal damping components while retaining the fork outer assemblies.
  • Lowered configuration to reduce ride height.

Tuning Controls

  • Compression adjustment.
  • Rebound adjustment.

Before You Install

  • Confirm compatibility with your exact model and any existing fork modifications.
  • Plan your setup around rider weight, typical luggage load, and intended terrain so the cartridges can be tuned appropriately after installation.

Serviceability/Lifecycle

Tractive suspension components are designed to be serviceable. Routine maintenance and periodic servicing help keep damping performance consistent over the life of the cartridge kit.

Teknik Motorsport Pty Ltd Warranty terms for TracTive products.

This TracTive product has been assembled with the utmost care and tested according to ISO9001:2015 Quality system. In the unlikely event that the product does not fulfill your expectations because of faulty materials or manufacturing errors, please contact us through your dealer.

Teknik Motorsport Pty Ltd warrants that if, within 24 months of the date of sale the product is found to be defective as a result of manufacturing errors or faulty components, the product will be repaired free of charge by us, or by a TracTive approved repairer at our discretion.

Warranty covers the direct service material cost, service labour cost ($80/hr AUD) and shipping costs of the service partner. Other costs will be regarded on a case by case basis by Teknik Motorsport and TracTive.

 When a claim is made under the warranty, the following conditions have to be met:

  • You must have read the instructions carefully before mounting the product in the vehicle or adjusting the product.
  • The product has to be installed and adjusted as described in the instructions
  • The product must have been maintained and serviced in accordance with the recommendations in the manual. If not described in the manual, the recommended service intervals for regular street use: every 30.000 km or max 2 years, whichever is earlier.
  • Warranty shall apply only when TracTive original parts, procedures and tools have been used to service and/or repair, and if service and repair is performed by designated TracTive partners.
  • The product may not have been neglected, improperly used, altered or subjected to excessive loads. Excluded from warranty are normal wear, damage and rust.
  • A sales receipt or other proof of purchase originally eminating from Teknik Motorsport Pty Ltd. No warranty will be given on TracTive or Touratech products not purchased from or through Teknik Motorsport pty ltd.
  • Excluded from warranty are in particular products which are used in vehicles that are intended or suitable for taking part in sporting events, or have actually been used this way.
  • Recommended service interval for Motorsport applications: every season, or every 50 hours, every 10.000km or after any perceived loss in performance.
SKU 35AP21-D5302-TR
Model # 35AP21-D5302-TR
Barcode # 35AP21D5302TR
Brand TracTive Suspension
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.900m
Unit Of Measure Set
Type X-TREME
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front
Damping Adjustment Type Rebound & Compression
Seat Height Change (mm) Lowered -20
Shock Length Eye to Eye (mm) 915.0
Spring Rate Standard 5.6 N/mm
Type Code X-TREME
Stroke Metal to Metal (mm) 220-10 (BUMP)
Notes Hydraulic end-stop
Fitted Spring 5.6-390

You May Also Like

More From This Category