The Ohlins STX 46 Street rear shock for the BMW K 1200 S and K 1300 S is built to improve damping control and chassis stability for road riding. It uses a gas-pressurised, oil/gas separated design to maintain consistent performance as conditions change. Valving and damping response are tuned to give clearer feedback and more predictable grip.

Ohlins | Made to race, perfected to ride

Developed from Ohlins race-program experience, the STX 46 Street platform focuses on controlled wheel movement and stability under load. The aim is confidence and consistency rather than harshness, with damping behaviour that supports traction through braking, turning and acceleration.

Shock design & features

This is a rear mono shock with a pressurised internal architecture that separates oil and gas for more stable damping during sustained use. The design supports fast response to road inputs and helps the rear tyre stay in contact with the surface for improved control.

Tuning controls

Adjustability is provided for rebound damping and compression damping, allowing you to tailor the feel for load, road quality and riding pace. These external controls let you refine support and compliance without changing internal components.

Base setup (factory preset)

The shock is supplied with an Ohlins baseline setting intended to work as a solid starting point for typical street use. From there, small changes to compression and rebound can be used to balance comfort, grip and chassis attitude to suit your preference.

Before you install

  • Confirm model compatibility for BMW K 1200 S and K 1300 S and check clearance around the shock body and adjusters.
  • Inspect linkage bearings and mounting hardware condition before fitting.
  • After installation, re-check fastener torque and verify full suspension travel without interference.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM446
Model # S46PR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 334.0
Spring Rate Standard 100.0 N/mm
Type Code S46PR1C1S
Stroke Metal to Metal (mm) 78.0
Product Family STX 46 Street
Fitted Spring 01092-34
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category