The Ohlins BM949 STX 46 Adventure rear shock is designed for riders who want dependable control and comfort from their BMW K 1 across varied road conditions. Built around Ohlins’ proven STX architecture, it’s intended to keep the rear end composed when surfaces change and loads vary. External adjustments make it practical to fine-tune for different riding demands.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on consistent damping behaviour, durability, and tunability. This unit is part of the STX 46 Adventure family, aimed at riders covering distance who still want accurate chassis control.

Shock design & features

This is a rear mono shock with a gas-separated design to help maintain damping consistency under sustained use. The STX layout is intended to offer stable performance through long runs and changing conditions while maintaining a controlled feel at the rear wheel.

Tuning controls

The BM949 includes rebound damping adjustment and compression damping adjustment for shaping how the shock responds to bumps and load transfers. It also features spring preload adjustment to suit rider weight, luggage, or a pillion and to set ride height correctly.

Is it right for you?

  • Suited to BMW K 1 owners wanting a more controlled and tuneable rear suspension.
  • A good match for riders who vary loads (solo vs luggage/pillion) and need preload adjustment to keep the bike balanced.
  • Ideal if you want access to both compression and rebound adjustments for more precise setup.

Before you install

Confirm fitment for your exact BMW K 1 model and check your linkage and mounting hardware condition before installation. After fitting, set sag with preload first, then use the damping adjusters to refine comfort and control for your riding conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM949
Model # S46HR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 382.0
Spring Rate Standard 46.0 N/mm
Type Code S46HR1C1S
Stroke Metal to Metal (mm) 93.0
Product Family STX 46 Adventure
Fitted Spring 01099-07

More From This Category