The Ohlins FGK210 NIX 30 fork cartridge kit is designed to improve front-end control and feedback for Ducati 1098, 1198, and 848 models. Built around the NIX 30 concept, it focuses on more consistent damping and clearer feel under braking and through corners. It suits riders chasing a more composed and communicative front end for fast road use and track days.

Ohlins | Made to race, perfected to ride

Ohlins cartridge kits are developed to deliver predictable damping behaviour and repeatable adjustment. The FGK210 is intended as a direct performance-focused internal upgrade to the front fork assembly.

Who this kit is for

  • Ducati riders wanting improved braking stability and front-end confidence
  • Fast road riders looking for better mid-corner support and feedback
  • Track-day riders needing more precise damping control than standard internals

Fork design & features

  • NIX 30 cartridge design for refined damping control
  • Premium internal components aimed at consistent performance and durability
  • Improves front-end composure and communication during spirited riding

Tuning controls

  • Separate compression and rebound adjustment for targeted fine-tuning
  • Adjustability intended to help balance braking support, turn-in feel, and mid-corner control

Before you install

  • Confirm compatibility with your Ducati 1098, 1198, or 848 variant before fitting
  • Installation requires fork disassembly and correct oil fill procedures
  • After installation, set sag and baseline clickers before making changes one at a time

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGK210
Model # NIX 30
Barcode # FGK210
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code NIX 30
Fork Length (mm) 717.0
Stroke Metal to Metal (mm) 120.0
Product Family NIX 30
Notes 08790-xx series spring
Fitted Spring Sold separately. See notes.

More From This Category