The Ohlins HD146 is a rear STX 36 twin shock set built for Harley-Davidson Sportster XL models where ride control and damping consistency matter. It uses a gas-pressurised, oil/gas separated design to help maintain stable damping during sustained use. The result is a more controlled rear end under braking, acceleration and mid-corner load changes.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered around predictable damping behaviour and repeatable adjustment. This STX 36 twin setup is designed to sharpen chassis response without losing the compliance needed for real roads.

Who this shock is for

Suited to Sportster XL riders who want more stability and feedback than typical stock or basic replacements. It’s aimed at riders who value a planted feel through corners and better control when riding briskly or carrying extra load.

Shock design & features

This is a twin shock rear arrangement from the Ohlins STX 36 family. The damper is gas-pressurised with oil/gas separation to reduce fade and help keep damping consistent. Internal valving is intended to improve traction and chassis calmness as conditions change.

Tuning controls

Adjustment is provided for rebound and compression damping, allowing you to tune how the rear settles after bumps and how it resists movement under load. This makes it easier to tailor feel for different roads, tyres and riding pace.

Before you install

Confirm fitment for Harley-Davidson Sportster XL and check that the supplied springs match your intended load and use. After installation, set sag and then make small, methodical damping changes to balance comfort, grip and stability.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD146
Model # S36E
Barcode # HD146
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 360.5
Spring Rate Standard 15.0 - 24.0 N/mm Progressive
Type Code S36E
Stroke Metal to Metal (mm) 98.0
Product Family STX 36 Twin
Fitted Spring 60480-51 00480-01
Spring Colour Black

More From This Category