The Ohlins HD202 STX 36 Twin is a rear twin-shock solution for Harley-Davidson VRSCA V-Rod models, built around Ohlins’ STX architecture. It’s designed to deliver controlled damping response and clear feedback through the chassis. The gas-pressurised design supports consistent performance across changing conditions.

Ohlins | Made to race, perfected to ride

Developed from Ohlins race-derived experience, this unit focuses on stability, traction and predictable behaviour when the pace increases. It’s intended for riders who want a suspension package they can tune rather than simply replace.

Who this shock is for

Suited to V-Rod owners chasing improved chassis control and confidence during faster road riding. It’s also a strong fit if you regularly adjust suspension to match load, tyres, or road conditions.

Shock design & features

This is a gas-pressurised rear twin-shock design from the STX 36 family. The pressurised damping system is aimed at maintaining damping consistency and helping manage heat-related fade during demanding use.

Tuning controls

Provides independent compression and rebound damping adjustment, allowing you to separate support (compression) from wheel-control and recovery (rebound). This makes it easier to fine-tune grip, stability and ride feel without changing hardware.

Before you install

  • Confirm fitment for your Harley-Davidson VRSCA V-Rod model and any existing modifications.
  • Set sag and baseline damping settings after installation to match rider weight and typical load.
  • Inspect mounting hardware and bushes during installation and replace worn components as required.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD202
Model # S36K
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 320.0
Type Code S36K
Stroke Metal to Metal (mm) 64.0
Product Family STX 36 Twin
Fitted Spring 03195-08

More From This Category