The Ohlins HD215 STX 36 Twin rear shock set is built for Harley-Davidson Dyna FXD models needing controlled damping and stable chassis behaviour. Based on Ohlins race-derived architecture, it focuses on consistent response and predictable grip across changing road conditions. The design is gas pressurised to help maintain damping consistency during extended riding.

Ohlins | Made to race, perfected to ride

STX 36 Twin units are engineered to give clear feedback and improved stability without making the ride feel vague or unsettled. The valving is intended to support traction and composure when load and pace change.

Who this shock is for

Suited to riders of Harley-Davidson Dyna FXD models who want more control from the rear end in real-world riding, including spirited road use. It’s aimed at riders who value adjustability and repeatable damping performance from a quality twin-shock package.

Shock design & features

  • STX 36 Twin rear shocks for twin-shock Harley-Davidson applications
  • Gas-pressurised, oil/gas separated design to support consistent damping
  • Race-developed damping concept adapted for road use

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

  • Confirm fitment for Harley-Davidson Dyna FXD with a rear twin-shock layout
  • Inspect mounting hardware and bushings during installation and torque to the motorcycle manufacturer’s procedure
  • Set sag and re-check fasteners after the first rides

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD215
Model # S36PR1C1L
Barcode # HD215
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 340.0 +5/-5
Spring Rate Standard 32.0 N/mm
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 88.0
Product Family STX 36 Twin
Fitted Spring 66422-032 21180-01
Spring Colour Black

More From This Category