The Ohlins HD907 STX 36 Twin rear shock set is built for Harley-Davidson XR 1200 fitment where stable damping control and predictable chassis behaviour matter. This twin-shock layout is designed to maintain consistent response through changing road conditions and riding loads. It provides external tuning so you can tailor feel and support without internal modifications.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on damping control, consistency and serviceability. The HD907 follows that approach with a robust STX 36 Twin architecture intended for performance road use on the XR 1200 platform.

Who this shock is for

  • XR 1200 riders wanting a more controlled, planted rear end from a twin-shock setup
  • Owners who value adjustability for different roads and riding styles
  • Riders looking for a serviceable rear suspension solution from Ohlins

Shock design & features

This is an oil/gas separated, gas-pressurised twin-shock design (STX 36 Twin) aimed at maintaining damping consistency during use. The gas pressure supports stable damping behaviour and helps reduce fade as conditions and temperatures change.

Tuning controls

The HD907 provides external damping adjustment for both compression and rebound, allowing you to balance comfort, support and traction to suit your riding and set-up goals.

Before you install

  • Confirm model compatibility for Harley-Davidson XR 1200 and rear twin-shock mounting
  • Inspect mounting hardware and bearings/bushes during fitment and replace if worn
  • After installation, re-check fastener torque and verify full, free suspension movement

Serviceability/lifecycle

As an Ohlins unit, the HD907 is designed to be serviced to maintain performance over time. Periodic servicing helps keep damping consistent and supports long-term reliability.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD907
Model # S36PL
Barcode # HD907
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 360.0 +10/-0
Spring Rate Standard 16.0 - 26.0 N/mm Progressive
Type Code S36PL
Stroke Metal to Metal (mm) 98.0
Product Family STX 36 Twin
Fitted Spring 60480-02 00480-02
Spring Colour Black

More From This Category