The Ohlins HD916 STX 36 Twin rear suspension is a twin-shock unit built for Harley-Davidson Sportster XL fitment. It uses gas-pressurised damping to help maintain consistent control as conditions change. The design is aimed at improving chassis stability and feel without overcomplicating setup.

Ohlins | Made to race, perfected to ride

STX technology brings Ohlins’ race-developed approach to a road-focused twin-shock layout. The HD916 is intended as a direct replacement option for Sportster XL models that run rear twin shocks.

Who this shock is for

  • Sportster XL riders wanting a higher level of damping control than basic twin shocks
  • Owners chasing more consistent rear-end behaviour through braking, cornering and acceleration
  • Riders who value tunability to suit different loads and road conditions

Shock design & features

  • STX 36 Twin architecture for rear twin-shock applications
  • Gas-pressurised damping to reduce fade and keep damping behaviour consistent
  • Race-proven valving approach focused on traction and stability

Tuning controls

The HD916 provides damping adjustment for both compression and rebound, allowing you to balance comfort, grip and chassis control to suit your riding style and conditions.

Before you install

  • Confirm your Sportster XL model and any existing aftermarket parts that may affect clearance
  • Set initial adjusters to a sensible baseline before road testing and making small changes
  • Plan setup around your typical load (solo, luggage, or passenger) for best results

Serviceability/lifecycle

Like other Ohlins units, this shock is designed to be serviced to maintain performance over time. Regular inspection and periodic servicing help keep damping consistent and components in good condition.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD916
Model # S36E
Barcode # HD916
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 338.0
Spring Rate Standard 12.0 - 19.0 N/mm Progressive
Type Code S36E
Stroke Metal to Metal (mm) 103.0
Product Family STX 36 Twin
Notes *Replaces HD 916E*
Fitted Spring 00480-02
Spring Colour Black

More From This Category