The Ohlins KA964 STX 36 Blackline rear shock pair is designed for the Kawasaki ZRX 1200, combining classic appearance with modern damping control. This twin-shock setup is intended to improve stability and ride quality while keeping the bike’s character intact. It’s a serviceable, tuneable suspension unit suited to road use where consistent feel matters.

Ohlins | Made to race, perfected to ride

Built around Ohlins STX technology, this Blackline pair focuses on controlled damping and predictable feedback. The twin rear layout suits motorcycles that rely on two rear units for both support and chassis balance.

Who this shock is for

Suited to riders of the ZRX 1200 who want a more planted rear end and improved compliance over imperfect surfaces. Also a good fit for owners aiming for a high-quality suspension refresh on a street-focused, classic-styled machine.

Shock design & features

This is an oil and gas separated shock design to help maintain damping consistency in real-world riding. The STX 36 Blackline family is intended to deliver stable performance with a finish that matches classic and custom builds.

Tuning controls

  • Rebound damping adjustment to manage how quickly the shock extends after a bump or load change
  • Compression damping adjustment to control shock movement under bumps and weight transfer
  • Spring preload adjustment to set ride height and support for rider/load

Before you install

  • Confirm correct fitment for Kawasaki ZRX 1200 and that both units are installed as a matched pair
  • Set sag and preload first, then refine damping in small steps to suit tyres, load, and road conditions
  • If your bike has other chassis modifications, plan on a baseline check of geometry and clearances after installation

Serviceability/lifecycle

As an Ohlins unit, the shocks are designed to be serviced to maintain performance over time. Periodic inspection and servicing helps keep damping consistent and preserves internal components.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA964
Model # S36PR1C1L (B)
Barcode # KA964
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 377.0 +6/-4
Spring Rate Standard 20.3 - 28.6 N/mm Progressive
Type Code S36PR1C1L (B)
Stroke Metal to Metal (mm) 94.0
Product Family STX 36 Blackline
Fitted Spring 00480-23
Spring Colour Black

More From This Category