The Ohlins STX 46 Street rear shock is a model-specific upgrade for classic Ducati 750 and 900 platforms. Built around Ohlins monotube damping architecture, it is designed to improve chassis control, traction and stability under real-world road loads. This unit uses a separated oil/gas design to help maintain consistent damping performance as temperatures and pace increase.

Ohlins | Made to race, perfected to ride

STX is Ohlins street-focused shock technology developed from their competition suspension programs. The aim is predictable support through corners and better control during braking and acceleration, without turning the bike into a compromise for everyday riding.

Shock design & features

This rear shock is based on the Ohlins 46 mm piston platform and uses a pressurised gas system with oil/gas separation rather than an emulsion layout. That architecture is intended to reduce aeration and keep damping behaviour more consistent during repeated high-load events.

Tuning controls

Adjustment is provided for rebound damping and compression damping, allowing you to balance grip and chassis stability to suit tyres, load and riding style. Spring preload is also adjustable to set ride height and sag correctly for the rider and any carried weight.

Base setup (factory preset)

The shock is supplied with an Ohlins baseline setting intended to suit the standard motorcycle configuration. Fine-tuning is typically done after sag is set, then rebound and compression are adjusted to match road conditions and rider preference.

Before you install

  • Confirm fitment for your Ducati model and year, and check clearances around the shock and linkage.
  • Set rider sag and free sag before making damping changes.
  • If you change tyres, ride height or load, revisit preload and damping settings.

Serviceability/lifecycle

Ohlins shocks are fully serviceable, with wear parts and oil designed to be replaced as part of normal maintenance. Regular servicing helps keep damping response consistent and protects internal components over the life of the unit.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU235
Model # S46PR1C1L
Barcode # DU235
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 328.0 +12/-0
Spring Rate Standard 85.0 N/mm
Type Code S46PR1C1L
Stroke Metal to Metal (mm) 68.0
Product Family STX 46 Street
Fitted Spring 01092-26
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category