The Ohlins TTX Flow DV rear shock is engineered for the Suzuki RM-Z 250 where consistent damping control and clear feedback matter. Built around Ohlins’ twin-tube damping architecture, it is designed to maintain stability and traction as track conditions change. This unit is supplied without a spring, allowing the spring rate to be selected to suit the rider and application.

Ohlins | Made to race, perfected to ride

TTX Flow DV is Ohlins’ approach to delivering repeatable damping behaviour and a planted feel through a wide range of inputs. The design is intended to keep the rear of the bike composed under acceleration, braking and cornering loads, helping the chassis stay balanced and predictable.

Shock design & features

  • Twin-tube (TTX) damping layout to promote consistent control and response
  • Gas-pressurised design with oil/gas separation to help reduce fade during demanding use
  • Rear mono shock configuration for the RM-Z 250 application

Tuning controls

This shock provides external damping adjustment for compression and rebound, allowing changes to be made for track conditions, grip level and rider preference. The independent adjustment circuits are intended to make it easier to fine-tune feel without masking other changes in the setup.

Before you install

  • Spring not supplied; select and fit the correct spring series as noted for this application
  • Confirm fitment for the Suzuki RM-Z 250 rear shock position prior to installation
  • Use the recommended Ohlins shock oil where servicing is required

Serviceability/lifecycle

As a rebuildable Ohlins unit, the shock is designed to be serviced with fresh oil and seals to keep damping performance consistent over time. Regular servicing intervals should be based on hours of use and riding conditions, especially in motocross and enduro environments.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU SU2193
Model # T46PR1C2W
Barcode # SU2193
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 480.0
Spring Rate No Spring/s Supplied
Type Code T46PR1C2W
Product Family TTX Flow DV
Notes 06310- & 06451- spring series *Replaced by DMX 0211*
Fitted Spring Sold separately, see notes.
Rec. Ohlins Oil 01304-

More From This Category