The Tractive X-PERIENCE rear shock for the BMW R nineT Scrambler is a closed, pressurised monotube design with an internal separation piston to keep oil and gas separated for consistent damping. It uses an external reservoir mounted to the shock body and provides full external adjustability for tailoring comfort, support and control. This unit includes a coil spring and a hydraulic preload adjuster, allowing quick ride-height support changes for different loads.

Design & features

  • Closed, pressurised shock architecture for stable performance over varying conditions
  • Oil/gas separation piston design (not an emulsion shock)
  • Fixed external reservoir for improved oil volume and heat management
  • Supplied with spring and hydraulic preload adjuster for tool-free preload changes

Tuning Controls

  • Rebound damping adjustment
  • Compression damping adjustment
  • High-speed compression damping adjustment
  • Hydraulic preload adjustment

Who is this for?

  • Riders who want broad tuning range for road use across mixed surfaces
  • Owners who regularly change load (solo, luggage, or passenger) and want fast preload changes
  • Riders seeking consistent damping feel from a pressurised, oil/gas-separated shock design

Base Setup (factory preset)

This shock is supplied with Tractive’s baseline settings as a starting point. Final setup will depend on rider mass, typical load, tyre choice and riding style.

Before You Install

  • Confirm fitment for your exact BMW R nineT Scrambler variant and model year
  • Check clearance around the reservoir and hose routing is not required on this fixed-reservoir configuration
  • Set sag and preload first, then fine-tune damping adjustments

Serviceability/Lifecycle

The shock is fully serviceable and can be maintained with routine oil and seal replacement to keep performance consistent over time. Service intervals depend on use conditions and mileage.

Teknik Motorsport Pty Ltd Warranty terms for TracTive products.

This TracTive product has been assembled with the utmost care and tested according to ISO9001:2015 Quality system. In the unlikely event that the product does not fulfill your expectations because of faulty materials or manufacturing errors, please contact us through your dealer.

Teknik Motorsport Pty Ltd warrants that if, within 24 months of the date of sale the product is found to be defective as a result of manufacturing errors or faulty components, the product will be repaired free of charge by us, or by a TracTive approved repairer at our discretion.

Warranty covers the direct service material cost, service labour cost ($80/hr AUD) and shipping costs of the service partner. Other costs will be regarded on a case by case basis by Teknik Motorsport and TracTive.

 When a claim is made under the warranty, the following conditions have to be met:

  • You must have read the instructions carefully before mounting the product in the vehicle or adjusting the product.
  • The product has to be installed and adjusted as described in the instructions
  • The product must have been maintained and serviced in accordance with the recommendations in the manual. If not described in the manual, the recommended service intervals for regular street use: every 30.000 km or max 2 years, whichever is earlier.
  • Warranty shall apply only when TracTive original parts, procedures and tools have been used to service and/or repair, and if service and repair is performed by designated TracTive partners.
  • The product may not have been neglected, improperly used, altered or subjected to excessive loads. Excluded from warranty are normal wear, damage and rust.
  • A sales receipt or other proof of purchase originally eminating from Teknik Motorsport Pty Ltd. No warranty will be given on TracTive or Touratech products not purchased from or through Teknik Motorsport pty ltd.
  • Excluded from warranty are in particular products which are used in vehicles that are intended or suitable for taking part in sporting events, or have actually been used this way.
  • Recommended service interval for Motorsport applications: every season, or every 50 hours, every 10.000km or after any perceived loss in performance.
SKU 46BM16-T4342-TR
Model # 46BM16-T4342-TR
Barcode # 46BM16T4342TR
Brand TracTive Suspension
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.400m
Unit Of Measure ea
Type X-PERIENCE
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear
Damping Adjustment Type Rebound & Compression High + Low Speed
Shock Options - Hydraulic Preload Adjuster Hydraulic with knob
Seat Height Change (mm) Raised +40
Shock Length Eye to Eye (mm) 386.0
Spring Rate Standard 140 N/mm
Type Code X-PERIENCE
Stroke Metal to Metal (mm) 67.0
Fitted Spring 140-180

More From This Category