The Tractive X-TREME rear shock for the KOVE 450 RALLY is built around a closed, pressurised 46 mm damper body with a separated oil and gas design to help maintain consistent damping as conditions change. It uses an external reservoir with a hose-mounted layout, and includes a spring and a hydraulic preload adjuster for practical load changes without tools.

Design & features

  • Closed, pressurised monotube architecture with separated oil and gas
  • External reservoir with hose mounting
  • Spring included
  • Hydraulic preload adjuster for easier preload changes

Tuning Controls

  • Triple-adjustable damping: rebound, plus two compression circuits (typically high- and low-speed)
  • Hydraulic preload adjustment

Base Setup (factory preset)

This shock is supplied with a factory baseline setup intended as a starting point. Final settings should be confirmed after installing and setting sag for rider weight, luggage and typical terrain.

Before You Install

  • Confirm compatibility with your exact KOVE 450 RALLY model and build year before fitting
  • Set sag after installation and re-check after initial use
  • Inspect linkage bearings and mounting hardware condition during installation

Serviceability/Lifecycle

As a closed, pressurised shock with a separated oil and gas system, it is designed to be serviced to maintain performance over time. Service intervals depend on use, load and operating conditions.

Is It Right For You?

This option suits riders who want broad adjustability and consistent damping from a pressurised, reservoir-equipped shock, with the convenience of hydraulic preload changes for varying loads.

Teknik Motorsport Pty Ltd Warranty terms for TracTive products.

This TracTive product has been assembled with the utmost care and tested according to ISO9001:2015 Quality system. In the unlikely event that the product does not fulfill your expectations because of faulty materials or manufacturing errors, please contact us through your dealer.

Teknik Motorsport Pty Ltd warrants that if, within 24 months of the date of sale the product is found to be defective as a result of manufacturing errors or faulty components, the product will be repaired free of charge by us, or by a TracTive approved repairer at our discretion.

Warranty covers the direct service material cost, service labour cost ($80/hr AUD) and shipping costs of the service partner. Other costs will be regarded on a case by case basis by Teknik Motorsport and TracTive.

 When a claim is made under the warranty, the following conditions have to be met:

  • You must have read the instructions carefully before mounting the product in the vehicle or adjusting the product.
  • The product has to be installed and adjusted as described in the instructions
  • The product must have been maintained and serviced in accordance with the recommendations in the manual. If not described in the manual, the recommended service intervals for regular street use: every 30.000 km or max 2 years, whichever is earlier.
  • Warranty shall apply only when TracTive original parts, procedures and tools have been used to service and/or repair, and if service and repair is performed by designated TracTive partners.
  • The product may not have been neglected, improperly used, altered or subjected to excessive loads. Excluded from warranty are normal wear, damage and rust.
  • A sales receipt or other proof of purchase originally eminating from Teknik Motorsport Pty Ltd. No warranty will be given on TracTive or Touratech products not purchased from or through Teknik Motorsport pty ltd.
  • Excluded from warranty are in particular products which are used in vehicles that are intended or suitable for taking part in sporting events, or have actually been used this way.
  • Recommended service interval for Motorsport applications: every season, or every 50 hours, every 10.000km or after any perceived loss in performance.
SKU 46KO24-T7501-TR
Model # 46KO24-T7501-TR
Barcode # 46KO24T7501TR
Brand TracTive Suspension
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.400m
Unit Of Measure ea
Type X-TREME
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear
Damping Adjustment Type Rebound & Compression High + Low Speed
Shock Options - Hydraulic Preload Adjuster Hydraulic with knob
Seat Height Change (mm) Standard Height
Shock Length Eye to Eye (mm) 452.0
Spring Rate Standard 65 N/mm
Type Code X-TREME
Stroke Metal to Metal (mm) 124
Notes PDSII anti-bottoming
Fitted Spring 65-235

More From This Category