The Ohlins TTX30 Professional Motorsport shock absorber is designed for Crosskart and Crosskart Xtreme competition use. It uses Ohlins TTX twin-tube damping architecture to maintain consistent damping behaviour and pressure balance under demanding conditions. Delivered as a pair, this unit is intended to be matched to the chassis, mounting hardware and spring choice for the specific application.

Ohlins | Made to race, perfected to ride

Built around Ohlins’ TTX concept, this shock is aimed at serious motorsport users who need stable, repeatable damping and a broad tuning window. Suitability depends on the vehicle build and intended use.

Who this shock is for

For professional Crosskart and Crosskart Xtreme applications where suspension performance must remain consistent through long runs and changing track conditions. Ideal when you have the ability to select appropriate springs and supporting hardware to suit the chassis.

Shock design & features

  • TTX twin-tube damping technology for controlled pressure balance and stable damping behaviour
  • Fully serviceable design
  • Supplied with spring installation hardware
  • Springs are ordered separately
  • End eye is ordered separately
  • Delivered as a pair (two shock absorbers per part number)

Tuning controls

Compression and rebound damping are adjusted separately, allowing you to tune chassis support and wheel control independently to suit the track and driving style.

Before you install

Confirm fitment and mounting requirements for your Crosskart chassis, including length/stroke selection, end-eye choice and spring specification. Compatibility and component selection can vary between builds, so planning the full assembly before installation is recommended.

Serviceability/lifecycle

This is a fully serviceable motorsport damper. Routine servicing helps maintain damping consistency and performance over time, particularly in high-load competition use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU AT074
Barcode # AT074
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category