The Ohlins KA036 TTX RT rear shock is a direct-fit rear mono shock for the Kawasaki ZX-10R. Built around Ohlins TTX architecture, it is designed to deliver consistent damping control and clear chassis feedback under demanding riding. This unit uses a separated oil/gas design to help maintain damping stability during extended use.

Ohlins | Made to race, perfected to ride

Ohlins TTX RT shocks bring race-derived damping layout to a street and trackday-ready package. The focus is predictable support, traction feel and repeatable performance, lap after lap.

Who this shock is for

  • ZX-10R riders chasing more controlled rear support and clearer feel when pushing on road or track
  • Riders who want a quality rear shock with external adjustability for proper set-up
  • Owners replacing a worn or inconsistent OE shock with a serviceable performance unit

Shock design & features

This is an Ohlins TTX RT rear mono shock with oil and gas separated for stable damping behaviour. The TTX layout uses twin-tube damping flow to help maintain consistent response through a wide range of conditions.

Tuning controls

The KA036 provides external adjustment for rebound damping, compression damping and spring preload. These controls let you balance support, grip and stability to suit rider weight, tyres and track or road conditions.

Before you install

  • Confirm application for your exact ZX-10R model and year before fitment
  • Set sag and baseline damping after installation to suit your riding and spring rate
  • Plan periodic servicing to keep oil condition and seals at their best over time

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU KA036
Model # T36PR1C1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 309.0 +6/-0
Spring Rate Standard 110.0 N/mm
Type Code T36PR1C1LS
Stroke Metal to Metal (mm) 59.0
Product Family TTX RT
Notes Repl.by KA 931
Fitted Spring 21040-39

More From This Category