The Ohlins AP822 STX 46 Supersport rear shock is designed to deliver consistent damping control and clear feedback for the Aprilia RSV mille SP. Built around a pressurised gas layout, it aims to maintain damping stability as operating temperatures change. The included adjusters allow practical chassis tuning for grip, support and balance.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience, the STX 46 Supersport platform focuses on predictable behaviour and repeatable setup changes. The goal is a stable, communicative rear end under braking, mid-corner load and acceleration.

Who this shock is for

This unit suits riders looking for more controlled rear suspension behaviour on road or track, and who want the ability to tune feel and support as tyres, pace and conditions change. It is a fit-for-application replacement shock for the RSV mille SP rear mono position.

Shock design & features

This is an oil and gas separated shock with a gas-pressurised damping system to reduce aeration and help resist damping fade. The STX 46 architecture is intended to keep damping response stable and consistent across longer sessions.

Tuning controls

  • Rebound damping: adjusts how quickly the shock extends after bumps and after acceleration squat, influencing stability and traction on corner exit.
  • Compression damping: adjusts resistance to load transfer under braking and cornering, affecting support and compliance.
  • Spring preload: adjusts initial spring tension and ride height balance, influencing chassis attitude and how the bike uses available travel.

Base setup (factory preset)

The supplied baseline tune is intended as a practical starting point for the Aprilia RSV mille SP with the fitted spring. From there, refine preload and damping to match rider weight, tyre choice and typical surface conditions.

Serviceability/lifecycle

Like all performance dampers, ongoing consistency depends on periodic servicing to refresh oil and seals and inspect wear items. Regular maintenance helps preserve damping accuracy, particularly when the bike is used hard.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU AP822
Model # S46PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 320.0 +6/-0
Spring Rate Standard 90.0 N/mm
Type Code S46PR1C1L
Stroke Metal to Metal (mm) 65.0
Product Family STX 46 Supersport
Fitted Spring 01091-29
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category