The Ohlins STX 36 Supersport rear shock for the Honda VTR 250 is built around race-derived damping control to improve stability, traction and feel. It’s designed to give clearer feedback through the chassis when braking, turning and driving out of corners. This unit uses a gas-pressurised, oil/gas separated design to help maintain consistent damping during demanding use.

Ohlins | Made to race, perfected to ride

Ohlins Supersport shocks are developed from track-focused architecture and tuned to suit spirited road and occasional circuit riding. The aim is predictable control and improved confidence without compromising serviceability. For the VTR 250 platform, the STX 36 layout is a proven fit for riders chasing better support and feel from the rear.

Who this shock is for

  • Riders upgrading from a tired or under-damped standard rear shock
  • Street riders wanting more composed handling under braking and acceleration
  • Track day riders needing repeatable damping and clearer rear grip feedback

Shock design & features

  • STX 36 Supersport architecture with a single-tube damper layout
  • Gas-pressurised, oil/gas separated design to reduce fade and improve consistency
  • Purpose-built rear mono fitment for the Honda VTR 250

Tuning controls

This shock provides external damping adjustment for both rebound and compression, allowing you to tailor support and grip to your tyres, pace and road surface. Adjustment is intended to be practical and repeatable for riders who want to fine-tune balance without changing hardware.

Before you install

  • Confirm your model and any year/trim differences for Honda VTR 250 fitment
  • Inspect linkage bearings and mounting hardware so the new shock can work as intended
  • Set sag and damping after installation to suit rider weight and riding conditions

Serviceability/lifecycle

Ohlins shocks are designed to be maintained, not discarded. Regular servicing helps keep damping performance consistent and extends component life, particularly if the bike sees hard road use or track days.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO944
Model # S36D
Barcode # HO944
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 295.0
Spring Rate Standard 160.0 N/mm
Type Code S36D
Stroke Metal to Metal (mm) 48.0
Product Family STX 36 Supersport
Fitted Spring 00281-36
Spring Colour Yellow

More From This Category