The Ohlins ARX0101 AR-X40 rear shock is a direct-fit replacement for the Yamaha Ténéré 700 and Ténéré 700 Rally Edition. It is designed to improve chassis control and rear-tyre connection across mixed road and adventure use. With adjustable damping, it lets you tune the rear of the bike to suit your load, pace, and typical terrain.

Ohlins | Made to race, perfected to ride

Ohlins shocks are built around controlled, repeatable damping behaviour so the bike remains predictable when conditions and pace change. The aim is consistent support and traction without relying on overly firm settings.

Who this shock is for

This shock suits riders using a Ténéré 700 for road riding, adventure touring, and variable surfaces where consistent rear stability matters. It is also relevant if you want clearer feel during braking and through mid-corner load changes.

Shock design & features

The ARX0101 is a complete rear mono shock replacement designed for the Ténéré 700 platform. It uses an oil/gas separated layout to help maintain damping consistency when conditions get rough and temperatures rise.

Tuning controls

  • Compression damping adjustment: helps tune how the rear reacts to bumps and load inputs, influencing support under acceleration and braking.
  • Rebound damping adjustment: helps tune how quickly the shock returns after compression, influencing grip, stability, and control over repeated bumps.

Before you install

Set the bike up for your normal riding load first, then fine-tune damping to balance support versus comfort. Make one change at a time and re-test on the same section of road or trail so you can clearly feel the direction of change.

Serviceability/lifecycle

Periodic servicing helps maintain damping consistency and seal life over time. Service needs vary with dust, water exposure, heat, and load, so inspection as part of routine maintenance is recommended.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU ARX0101
Model # T40PR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 371.0
Shock Length Eye to Eye (mm) 371
Spring Rate Standard 70.0 N/mm
Type Code T40PR1C1S
Stroke Metal to Metal (mm) 96.0
Product Family AR-X40
Fitted Spring 00698-19

Related products

More From This Category