The Ohlins STX 46 Supersport rear shock for the Bimota 500 Vdue is built around proven race-derived damping architecture for consistent control and clear chassis feedback. It is a rear mono shock designed to support confident cornering, braking stability, and traction on performance-focused road and track use. This unit uses a gas-pressurised design to help maintain damping consistency as conditions change.

Ohlins | Made to race, perfected to ride

Ohlins Supersport suspension focuses on predictable damping behaviour and repeatable adjustment. The aim is to give the rider a stable platform with the feel needed to refine setup without chasing inconsistency.

Who this shock is for

Suited to riders who want sharper response than a standard shock and the ability to tune the bike for tyres, pace, and track surfaces. It’s a logical choice for regular spirited riding and track days where stability and drive grip matter.

Shock design & features

This is an STX 46 Supersport rear mono shock with oil and gas separated by an internal reservoir layout. The gas-pressurised design is intended to reduce aeration and support stable damping performance during sustained hard use.

Tuning controls

This shock includes external adjustment for rebound damping and compression damping, allowing you to balance support and comfort while targeting stability on the brakes and traction on corner exit. Adjustments are designed to be used independently to fine-tune feel without upsetting overall control.

Before you install

  • Confirm correct fitment for Bimota 500 Vdue and check clearance around the linkage and exhaust.
  • Inspect existing bearings/bushes and replace worn components to avoid masking setup changes.
  • After installation, set sag and then use the damping adjusters to refine balance front-to-rear.

Serviceability/lifecycle

Like all high-performance shocks, periodic servicing helps maintain consistent damping and seal condition. A routine service schedule is recommended to keep performance predictable, particularly if the bike sees regular track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BI647
Model # S46PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 315.0 +12/-0
Spring Rate Standard 100.0 N/mm
Type Code S46PR1C1L
Stroke Metal to Metal (mm) 50.0
Product Family STX 46 Supersport
Fitted Spring 01091-34
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category