The Ohlins BM440 STX 46 Street rear shock is built to give the BMW R nineT a more controlled, predictable feel on the road. It uses a pressurised, separated oil/gas design to maintain damping consistency as conditions change. The focus is chassis stability, traction and clear feedback without compromising everyday rideability.

Ohlins | Made to race, perfected to ride

STX technology brings Ohlins’ track-learned damping behaviour into a street-focused package. The internal architecture is designed to keep damping response consistent and reduce heat-related fade during extended spirited riding.

Shock design & features

  • Pressurised, oil/gas separated layout for stable damping performance
  • Street-oriented valving aimed at improving tyre contact and chassis composure
  • Rear fitment for BMW R nineT applications

Tuning controls

  • Rebound damping adjustment to tailor control and stability
  • Compression damping adjustment to manage support under braking and corner loads

Before you install

  • Not suitable for use with HIGH Akrapovic OE accessory exhaust
  • Not suitable for 2017- bikes with Euro 4 (canister clearance)

Serviceability/lifecycle

Like all performance suspension, periodic servicing helps maintain damping quality and seal life. Keeping oil and internal wear parts fresh preserves the consistent feel this shock is designed to deliver.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM440
Model # S46PR1C1B
Barcode # BM440
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 368.0
Spring Rate Standard 160.0 N/mm
Type Code S46PR1C1B
Stroke Metal to Metal (mm) 46.0
Product Family STX 46 Street
Notes Not suitable for use with HIGH Acrapovic OE accessory exhaust. Not suitable for 2017- bikes with Euro 4 (Canister clearance).
Fitted Spring 01093-64
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category