The Ohlins BM503 STX 46 Street rear shock is a purpose-built replacement for BMW R 1200 RT applications where control and ride quality matter. Built around Ohlins road-going suspension know-how, it focuses on consistent damping and predictable chassis behaviour. This unit is designed for street and touring use, with practical adjustment to tailor feel to load and riding conditions.

Ohlins | Made to race, perfected to ride

Ohlins brings proven damping architecture into a road-focused package for riders who want clear feedback and stable handling. The STX 46 Street family is aimed at everyday riding and long-distance comfort without losing support when pace increases.

Who this shock is for

  • BMW R 1200 RT riders looking to refresh worn suspension with a higher-quality damper.
  • Touring and commuting riders who carry luggage or a passenger and want better control.
  • Riders who value adjustability to suit different roads and loads.

Shock design & features

This is a gas-charged, oil/gas-separated rear mono shock from the Ohlins STX 46 Street range. The separated gas design helps maintain damping consistency as conditions change, supporting stable behaviour over a wide range of road use.

Tuning controls

This shock provides rebound damping adjustment, allowing you to tune how quickly the rear recovers after bumps and weight transfer. Spring preload adjustment is used to set ride height and support for rider weight, luggage, and passenger load.

Before you install

  • Confirm fitment for BMW R 1200 RT and check any model-year or variant requirements before installation.
  • Set sag and preload first, then fine-tune rebound to suit your roads and riding style.
  • Inspect linkage bearings and mounting hardware condition during installation, as worn components can mask the benefits of a new shock.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced, with routine maintenance helping preserve damping quality and seal life over time. Periodic servicing is recommended, particularly for frequent touring or rough-road use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM503
Model # S46ER1
Barcode # BM503
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 330.0
Spring Rate Standard 60.0 N/mm
Type Code S46ER1
Stroke Metal to Metal (mm) 78.0
Product Family STX 46 Street
Notes Front
Fitted Spring 01096-14
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category