The Ohlins STX 46 Street rear shock for the BMW R nineT Scrambler and R nineT Urban G/S is built to deliver controlled damping and clear chassis feedback in real-world road use. It uses a pressurised gas damping system to maintain consistency as conditions and pace change. Designed as a direct-fit rear mono shock, it supports reliable traction and stability through braking, cornering and acceleration.

Ohlins | Made to race, perfected to ride

STX 46 Street products are developed from Ohlins’ competition experience and adapted for everyday riding. The focus is predictable damping behaviour, support through the stroke, and a setup window that suits mixed road surfaces.

Shock design & features

  • Rear mono shock architecture for BMW R nineT Scrambler and R nineT Urban G/S fitment
  • Pressurised gas damping system for consistent performance
  • STX 46 Street design intended for controlled response and stable chassis behaviour

Tuning controls

This shock provides external damping adjustment for both rebound and compression, allowing you to tune feel and support to suit load, tyres and road conditions. Adjustments are intended to be straightforward for street use while still offering meaningful changes in behaviour.

Base setup (factory preset)

Supplied with an Ohlins baseline setting to suit the intended application. This gives a workable starting point for road riding, with the option to fine-tune rebound and compression to preference.

Before you install

  • Confirm your exact model and year match for the BMW R nineT Scrambler and/or R nineT Urban G/S
  • Set sag and check clearances after installation, especially if you change load or luggage
  • Use the recommended Ohlins suspension oil specified for the unit during service

Serviceability/lifecycle

As an Ohlins rear shock, it is designed to be maintained over its service life. Periodic servicing helps keep damping consistent and protects internal components, particularly for riders covering higher kilometres or riding on rougher roads.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM642
Model # S46DR1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 374.0 +10/-0
Spring Rate Standard 140.0 N/mm
Type Code S46DR1LB
Stroke Metal to Metal (mm) 52.0
Product Family STX 46 Street
Fitted Spring 21102-54
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category