The Ohlins STX 46 Street front shock for BMW R 1100 R and R 850 R is built to improve front-end control and ride confidence in real-world road use. It uses a pressurised, oil/gas separated design to keep damping consistent as conditions change. The focus is stable support under braking and clear feedback through the bars.

Ohlins | Made to race, perfected to ride

Developed from Ohlins suspension engineering, the STX 46 Street range is aimed at predictable damping behaviour and dependable control for road riders. On these BMW models, the front mono shock plays a major role in steering accuracy and stability.

Shock design & features

This is a gas-pressurised monotube shock with separated oil and gas to reduce cavitation and maintain consistent damping. The internal layout is intended to deliver controlled movement through the stroke and improved composure when the front end is loaded.

Tuning controls

Adjustment is provided for rebound damping, allowing you to tune how quickly the front shock extends after compression. This helps tailor chassis attitude and grip feel to your riding style and road conditions.

Base setup (factory preset)

Supplied with an Ohlins-recommended baseline setup intended to suit typical street riding on the listed BMW applications. From that starting point, rebound adjustment can be used to fine-tune comfort, support, and steering response.

Before you install

This unit is intended as a direct-fit front shock for BMW R 1100 R and R 850 R. Installation should include correct fastener torque, alignment checks, and a post-install inspection to confirm free movement and proper clearance.

Serviceability/lifecycle

Like all performance dampers, regular servicing helps keep damping performance consistent over time. Periodic oil and seal refresh is recommended based on use and conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM634
Model # S46ER1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Mono
Shock Length Eye to Eye (mm) 327.0
Spring Rate Standard 52.0 N/mm
Type Code S46ER1
Stroke Metal to Metal (mm) 78.0
Product Family STX 46 Street
Notes Front
Fitted Spring 01096-10
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category