The Ohlins DU816 TTX RT rear shock absorber is built around the TTX concept for riders chasing consistent damping control on Ducati 1098R/Bayliss, 1098S and Streetfighter 1098 models. It uses a gas-pressurised, oil/gas separated design to help maintain stable performance as conditions change. Independent damping circuits allow clearer, more repeatable changes when tuning for grip, support and feedback.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing know-how, this unit is intended to deliver precise chassis control while retaining predictable feel. The focus is on damping consistency and tunability rather than compromise settings.

Who this shock is for

  • Riders upgrading the rear of a Ducati 1098R/Bayliss, 1098S or Streetfighter 1098 for more controlled damping behaviour
  • Track day and fast road riders who want independent adjustment of compression and rebound
  • Owners who value a dedicated rear mono shock with a motorsport-derived damping architecture

Shock design & features

  • TTX RT rear mono shock configuration
  • Gas-pressurised, oil/gas separated construction for consistent damping characteristics
  • Race-proven valving approach aimed at improving traction and stability

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • Confirm model fitment for Ducati 1098R/Bayliss, 1098S and Streetfighter 1098 applications
  • Set sag and balance front-to-rear before fine damping changes
  • Plan periodic servicing to keep damping performance consistent over the shock’s life

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU816
Model # T36PR1C1B
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 294.5
Spring Rate Standard 80.0 N/mm
Type Code T36PR1C1B
Stroke Metal to Metal (mm) 60.0
Product Family TTX RT
Notes Rear
Fitted Spring 21042-24

More From This Category