The Ohlins DU911 TTX RT rear shock is built for the Ducati 1198R, using race-developed damping architecture to deliver repeatable control and clear feedback. It is a gas-pressurised, oil/gas-separated design aimed at maintaining damping consistency under sustained load. Independent compression and rebound circuits allow you to tune grip, support and stability to suit your tyres and pace.

Ohlins | Made to race, perfected to ride

TTX technology is based around balanced damping behaviour to keep the chassis settled through rapid direction changes and heavy acceleration. The result is a shock that prioritises feel and consistency when you are pushing on track.

Who this shock is for

Suited to Ducati 1198R riders who ride quickly on track or fast road and want more adjustment range and damping control than a basic replacement shock. It is also appropriate if you are chasing improved rear tyre contact and predictable drive out of corners.

Shock design & features

This unit is a gas-pressurised, oil/gas-separated rear mono shock using Ohlins TTX RT architecture. The separation of oil and gas helps maintain damping stability during repeated high-load use and reduces the likelihood of fade.

Tuning controls

You can adjust rebound damping and compression damping independently, allowing more precise changes to how the rear end settles on corner entry and supports the bike on throttle. Spring preload adjustment is provided to set ride height and balance for rider weight and tyre choice.

Before you install

  • Confirm fitment for Ducati 1198R and check clearance around linkages, exhaust and bodywork.
  • Set sag and baseline damping after installation, then change one parameter at a time during testing.
  • Plan periodic servicing to keep performance consistent, especially with frequent track use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU911
Model # T36PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

If your Motorcycle is listed below, this product will suit:

Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 294.5
Spring Rate Standard 90.0 N/mm
Type Code T36PR1C1
Stroke Metal to Metal (mm) 60.0
Product Family TTX RT
Fitted Spring 21040-29

More From This Category