The Ohlins FKA108 FKA 100 Adventure Cartridge Front is designed to improve control and comfort for extended off-road riding on the KTM 690 Enduro R with WP forks. It focuses on maintaining stability across rough surfaces such as corrugations and rocky climbs. The result is a more composed front end and reduced rider fatigue on long days.

Ohlins | Made to race, perfected to ride

Developed as part of the FKA 100 Adventure Cartridge family, this front cartridge kit targets consistent damping performance in harsh conditions. It is intended to keep the bike tracking predictably when terrain and load vary.

Who this kit is for

  • Riders doing long-distance off-road travel where comfort and composure matter
  • Adventure setups carrying extra load such as luggage or a pillion
  • Owners wanting more confidence and stability from the front end on challenging terrain

Shock design & features

  • Front cartridge suspension kit for KTM 690 Enduro R (WP)
  • Durable construction intended for harsh riding conditions
  • Built to help the bike stay planted over rough ground

Tuning controls

  • External adjusters for quick trail-side tuning

Before you install

  • Confirm compatibility with KTM 690 Enduro R fitted with WP forks
  • Set up and adjustment should be completed carefully to suit terrain, load, and rider preference

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FKA108
Model # NIX 30 A
Barcode # FKA108
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code NIX 30 A
Fork Length (mm) 905.0
Stroke Metal to Metal (mm) 250.0
Product Family FKA 100
Notes Recommended spring 08427-55
Fitted Spring Sold separately, see notes.

More From This Category