The Ohlins FKA121 front cartridge kit is designed to improve control and consistency from the front end of your Honda CRF300 RALLY or CRF300L. Built around Ohlins cartridge technology, it targets better composure across mixed terrain and long-distance riding. It also aims to maintain stability when the bike is carrying extra load.

Ohlins | Made to race, perfected to ride

Developed for riders who want a more controlled, predictable front end in real-world conditions. The focus is on reducing rider effort while keeping the bike settled through rougher surfaces.

Who this cartridge kit is for

  • Adventure and dual-sport riders covering long distances
  • Riders tackling corrugations, rocky climbs and uneven tracks
  • Those carrying luggage and/or a pillion and wanting steadier front-end behaviour

Shock design & features

  • Front suspension cartridge kit (FKA 100 Adventure Cartridge family)
  • Robust construction intended for demanding riding conditions
  • Designed to help keep the bike planted and reduce fatigue over extended rides

Tuning controls

  • External adjusters for quick trail-side tuning

Before you install

  • Fitment: Honda CRF300 RALLY and CRF300L
  • Mounting position: Front
  • Fitted spring: 68042-35 / 68042-45

Serviceability/lifecycle

As an Ohlins cartridge kit, it is intended to be maintained and serviced over its life to keep performance consistent. Service intervals and procedures should be followed per Ohlins guidance.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FKA121
Model # NIX 30 A
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate Standard 3.5 / 4.5 N/mm
Type Code NIX 30 A
Fork Length (mm) 901.0
Stroke Metal to Metal (mm) 260.0
Product Family FKA 100
Notes Optional setting alternative for dual sport performance included.
Fitted Spring 68042-35 / 68042-45
Rec. Ohlins Oil 01309-

More From This Category