The Ohlins FKS229 NIX 22 fork cartridge kit is a front suspension upgrade for Yamaha Tracer 7 GT and Tracer 700/Tracer 7 (FJ-07) models. It is designed to improve front-end control and feel under braking and through corners. The aim is a more composed and communicative fork response for road riding with the option of occasional track use.

Ohlins | Made to race, perfected to ride

Ohlins cartridge kits replace the fork’s internal damping components to deliver more consistent control and clearer feedback at the handlebar. This kit focuses on stability when loading the front tyre and maintaining support as conditions change.

Who this kit is for

  • Riders wanting improved braking stability and mid-corner feel
  • Owners chasing a more controlled and confidence-inspiring front end on the street
  • Those who ride spirited roads and do occasional track days

Shock design & features

  • NIX 22 cartridge design for refined damping behaviour
  • Premium internal components for consistent performance and durability
  • Designed as a front-mounted cartridge upgrade for the listed Yamaha models

Tuning controls

  • Separate compression and rebound adjustment to fine-tune damping balance
  • Adjustability intended to make setup changes clear and repeatable

Before you install

  • Stroke length is listed as 130 mm in the supplied product notes
  • Fork springs are sold separately; confirm the correct spring options for your application

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FKS229
Model # NIX 22
Barcode # FKS229
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Spring Rate No Spring/s Supplied
Type Code NIX 22
Fork Length (mm) 740.0
Stroke Metal to Metal (mm) 130.0
Product Family NIX 22
Notes Spring series 08429-xx
Fitted Spring Sold separately. See notes.
Rec. Ohlins Oil 01309-

More From This Category