The Ohlins STX 36 rear shock pair for Honda PCX 125 and PCX 150 is built to improve control and consistency in everyday scooter use. Designed as a twin rear setup, it focuses on stable damping response and better chassis feedback across varying road surfaces. This unit is a gas-pressurised design to help maintain damping stability as conditions change.

Ohlins | Made to race, perfected to ride

Ohlins applies proven suspension design principles to deliver predictable behaviour and clear feel at the tyre. The aim is controlled movement rather than harshness, helping the scooter track cleanly and remain settled through braking and cornering.

Who this shock is for

  • PCX riders wanting a more controlled, confidence-inspiring rear end than stock
  • Commuters carrying varying loads who want consistent suspension behaviour
  • Riders who value clear feedback and stability on mixed-quality roads

Shock design & features

  • STX 36 scooter rear twin-shock configuration
  • Gas-pressurised damping to support consistent performance during use
  • Internal damping layout designed to deliver stable chassis behaviour and traction

Tuning controls

Compression and rebound damping are adjustable, allowing you to tailor support and control to suit your riding style, road conditions, and load.

Before you install

  • Confirm fitment for your specific Honda PCX 125 / PCX 150 variant and year
  • Install as a matched pair and check all mounting hardware condition
  • After installation, recheck fasteners and verify clearance through suspension travel

Serviceability/lifecycle

Ohlins units are designed to be maintained and serviced, supporting long-term performance when kept on a regular service schedule.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO427
Model # S36PC1
Barcode # HO427
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 313.0
Type Code S36PC1
Stroke Metal to Metal (mm) 88.0
Product Family STX 36 Scooter
Fitted Spring 60281-19
Spring Colour Yellow

More From This Category