The Ohlins STX 36 twin rear shock package for the Victory Octane is built around stable damping control and predictable chassis behaviour on the road. It’s designed to give clear feel at the tyre while keeping the bike composed through changing surfaces and load conditions. This is a matched twin-shock setup intended for street-focused performance tuning.

Ohlins | Made to race, perfected to ride

Ohlins twin-shock systems bring race-developed damping principles to road bikes where control and consistency matter most. The STX 36 architecture focuses on balanced damping response and serviceable construction for long-term ownership.

Who this shock is for

  • Victory Octane riders chasing more controlled rear-end behaviour than standard shocks can offer
  • Owners who want tuning flexibility for different roads, riding pace, and typical street loads
  • Riders who prefer a quality, serviceable twin-shock setup rather than a fit-and-forget unit

Shock design & features

This model uses an oil/gas separated monotube layout for consistent damping performance. The twin-shock arrangement is suited to the Octane’s rear suspension format and is engineered to deliver stable support and traction-focused behaviour across typical street conditions.

Tuning controls

You can tune both rebound damping and compression damping, along with spring preload. These external adjustments let you tailor support and feel for road surface changes and rider preference without internal revalving.

Serviceability/lifecycle

As an Ohlins unit, it is designed to be maintained and rebuilt as part of normal suspension servicing. Periodic oil and wear-part replacement helps keep damping performance consistent over time.

Before you install

  • Confirm correct fitment for the Victory Octane and check mounting hardware condition before installation
  • Set sag and preload first, then fine-tune rebound and compression in small steps
  • If you’re unsure on setup targets, record your current settings before making changes

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU VI642
Model # S36PR1C1L
Barcode # VI642
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 267.0 +6/-4
Spring Rate Standard 40.0 N/mm
Type Code S36PR1C1L
Stroke Metal to Metal (mm) 57.0
Product Family STX 36 Twin
Fitted Spring 60282-10
Spring Colour Black
Rec. Ohlins Oil 01309-

More From This Category