The Ohlins YA358 TTX RT rear shock absorber is built to suit the Yamaha YZF R6 with a focus on consistent damping control and clear chassis feedback. Developed from Ohlins racing experience, it is intended for riders who want a suspension package that can be tuned to track conditions and riding style. The TTX RT platform is designed to maintain stable behaviour over longer sessions by keeping damping performance consistent.

Ohlins | Made to race, perfected to ride

Ohlins TTX RT shocks are engineered for precise damping control and predictable feel at the limit. This unit is a direct-fit rear mono shock solution for the R6 and is aimed at riders who value adjustability and repeatable setup changes.

Who this shock is for

  • Riders using a Yamaha YZF R6 who want a dedicated Ohlins rear shock upgrade
  • Trackday and race users looking for sharper feedback and improved stability under braking and acceleration
  • Owners who want a shock designed for regular tuning and servicing

Shock design & features

This is a gas-pressurised, oil/gas separated shock design intended to reduce fade and keep damping characteristics consistent. The TTX RT architecture uses dedicated damping circuits to support controlled wheel movement and traction, particularly when the bike is loaded hard.

Tuning controls

  • Rebound damping adjustment
  • Compression damping adjustment

Before you install

This shock is specified as a rear mono application for the Yamaha YZF R6 and is supplied with the listed fitted spring. After installation, set sag and confirm damping settings are appropriate for your tyres, pace, and track surface before making further changes.

Serviceability/lifecycle

Ohlins shocks are designed to be serviced and revalved as required. Regular servicing helps maintain damping consistency and allows the setup to be refreshed as riding conditions or requirements change.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU YA358
Model # T36PR1C1L
Barcode # YA358
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 293.0 +5/-1
Spring Rate Standard 90.0 N/mm
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 60.0
Product Family TTX RT
Notes TTX RT
Fitted Spring 21041-29
Spring Colour Yellow

More From This Category