The Ohlins TTX30 shock absorber set is built for professional Crosskart and Crosskart Xtreme applications where stable damping behaviour and consistent performance are priorities. This unit uses Ohlins TTX twin-tube damping architecture to maintain controlled pressure balance through the stroke. Supplied as a pair, it is intended to be installed and tuned for the specific chassis and operating conditions.

Ohlins | Made to race, perfected to ride

Developed from Ohlins motorsport damping know-how, TTX technology is aimed at delivering repeatable response and a broad tuning window in competition environments. Correct installation and baseline setup are essential to get the best from the platform.

Who this shock is for

  • Crosskart and Crosskart Xtreme competitors needing a dedicated motorsport damper package
  • Drivers and builders who want separate compression and rebound adjustability for track-to-track changes
  • Applications where serviceability and rebuild support are part of the plan

Shock design & features

  • TTX twin-tube damping design for stable damping behaviour and pressure balance
  • Separate compression and rebound damping adjustment
  • Fully serviceable construction
  • Spring installation hardware included
  • Supplied as a pair (two shock absorbers per part number)

Tuning controls

Compression and rebound damping are adjusted separately, allowing you to tune support and control without relying on a single combined adjuster. This makes it easier to adapt the chassis to grip level, surface roughness and driver preference during testing and competition.

Before you install

  • Springs are ordered separately; select rates to suit the chassis, corner weights and intended conditions
  • End eye is ordered separately; confirm mounting requirements for your specific Crosskart
  • Compatibility and mounting details vary by chassis; verify fitment before assembly

Serviceability/lifecycle

The TTX30 is designed to be serviced and rebuilt as part of normal motorsport maintenance. Plan periodic servicing based on use, and keep damping settings and spring selections documented to streamline setup changes.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU AT072
Barcode # AT072
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions

More From This Category