The Ohlins STX 46 Street rear shock for BMW R 100 R and R 80 R is built to improve chassis control and feedback in real-world road use. It uses a mono-shock layout aimed at delivering consistent damping feel through changing loads and road surfaces. This unit is designed to let you tailor rebound behaviour to suit your bike setup and riding style.

Ohlins | Made to race, perfected to ride

Ohlins street-focused shocks are developed from competition suspension principles, with an emphasis on predictable response and mechanical grip. The goal is a planted rear end that supports confident corner entry, mid-corner stability and drive out of turns without harshness.

Who this shock is for

Suited to riders who want more control and composure from the rear of their BMW R 100 R or R 80 R on the street. It’s a practical choice when you’re chasing clearer feedback, improved stability under braking and a more settled ride over mixed road surfaces.

Shock design & features

This is an Ohlins STX 46 Street mono rear shock using a gas-pressurised design. Gas pressure helps maintain damping consistency during sustained riding by reducing foaming and fade, keeping the shock response more stable as conditions change.

Tuning controls

Rebound damping adjustment is provided to fine-tune how quickly the shock extends after compression. This lets you balance comfort, traction and chassis stability depending on tyres, load and riding pace.

Before you install

Confirm fitment for your specific model and year of BMW R 100 R / R 80 R, and check clearances with any accessories or luggage systems. After installation, set sag and then refine rebound damping in small steps to match your road conditions and riding preferences.

Serviceability/lifecycle

Like any performance shock, ongoing servicing helps maintain damping quality and seal life over time. Periodic inspection and oil service will keep performance consistent and extend the usable life of the unit.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM332
Model # S46DR1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 474.0
Spring Rate Standard 80.0 N/mm
Type Code S46DR1S
Stroke Metal to Metal (mm) 74.0
Product Family STX 46 Street
Fitted Spring 01096-24
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category