The Ohlins BM335 is a front mono shock for the BMW R 1100 RS, built around Ohlins STX 46 street-focused architecture. It is designed to provide consistent damping control and clearer chassis feedback for road riding. Adjustment is provided for rebound damping to help tailor the feel to your bike, load and riding conditions.

Ohlins | Made to race, perfected to ride

Ohlins road shocks draw on the same damping fundamentals used across the brand’s motorsport programs, refined for everyday usability. The goal is predictable support and improved control across changing surfaces and temperatures.

Shock design & features

This is a gas-charged monotube design with oil and gas separated to help maintain damping consistency. The STX 46 construction focuses on stable behaviour under braking and through corners, with a direct connection to front-end feel.

Tuning controls

Rebound damping adjustment is provided, allowing you to manage how quickly the shock extends after compressing. This is typically the primary control used to tune stability, steering feel and compliance over uneven roads.

Base setup (factory preset)

The shock is supplied with an Ohlins-fitted spring. Start with the installed baseline settings and make small changes one at a time, noting the effect before moving further.

Before you install

  • Confirm fitment for BMW R 1100 RS and front mono position before installation.
  • Inspect mounting hardware, bearings/bushings and related suspension components, replacing worn parts as required.
  • After installation, re-check fasteners and clearances and verify operation through full steering movement.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM335
Model # S46ER1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front Mono
Shock Length Eye to Eye (mm) 320.0
Spring Rate Standard 52.0 N/mm
Type Code S46ER1
Stroke Metal to Metal (mm) 71.0
Product Family STX 46 Adventure
Notes Front
Fitted Spring 01096-10
Spring Colour Yellow

More From This Category