The Ohlins STX 46 Blackline rear shock for the BMW R nineT Scrambler and R nineT Urban G/S is built to improve control and ride quality while keeping a clean, classic look. Designed as a rear mono shock, it offers practical tuning for real-world road riding. A factory baseline setup is provided as a starting point, with adjustment range to suit rider preference and load.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on consistent damping performance and predictable feedback. The STX 46 Blackline family pairs that engineering approach with a dark finish suited to heritage and custom-style bikes.

Shock design & features

This is an STX 46 rear mono shock with separated oil and gas to help maintain damping consistency. The architecture is intended to deliver stable behaviour through a range of road conditions, with a layout that supports tuning without changing the bike’s character.

Tuning controls

  • Rebound damping adjustment to fine-tune how quickly the shock returns after compression
  • Compression damping adjustment to manage support and bump absorption
  • Spring preload adjustment to suit rider weight and luggage

Base setup (factory preset)

Ohlins supplies this unit with a factory preset as a sensible starting point for general street use. From there, the rebound, compression and preload adjusters let you refine comfort, support and chassis balance to match your riding and typical loads.

Before you install

Confirm fitment for your exact BMW R nineT Scrambler or R nineT Urban G/S variant and model year before installation. After fitting, set static sag using preload, then use small adjustment changes to rebound and compression to keep the bike balanced front-to-rear.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM496
Model # S46PR1C1LB (B)
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 374.0 +7/-5
Spring Rate Standard 160.0 N/mm
Type Code S46PR1C1LB (B)
Stroke Metal to Metal (mm) 52.5
Product Family STX 46 Blackline
Fitted Spring 21102-64
Spring Colour Black

More From This Category