The Ohlins STX 46 Street rear shock for the BMW R 1100 RT is built to deliver controlled damping and stable chassis behaviour for road riding. It uses a pressurised gas damping system to help maintain consistency as conditions change. The design supports precise tuning so you can match the bike to load, tyres and riding style.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience and adapted for street use, the STX 46 Street range focuses on predictable grip and feedback. For the R 1100 RT, it targets improved stability and composure without sacrificing ride quality.

Who this shock is for

  • Riders looking for a more controlled and settled rear end on the road
  • Owners who ride with varied loads and want adjustable damping
  • Anyone chasing clearer feedback during braking and cornering

Shock design & features

This is a gas-pressurised rear mono shock from the Ohlins STX 46 Street family. The pressurised design is intended to support consistent damping behaviour and stability during sustained use.

Tuning controls

The shock provides rebound damping adjustment and a spring preload adjuster, allowing you to balance support and comfort for your setup. These adjustments help tailor the bike’s response to road conditions, riding pace and carried weight.

Before you install

  • Confirm fitment for BMW R 1100 RT and rear mono position before installation
  • Set sag and preload first, then fine-tune rebound to suit your riding
  • Inspect bearings and mounting hardware condition during the swap

Serviceability/lifecycle

As with any performance shock, periodic servicing helps maintain damping quality over time. Keeping oil and seals fresh supports consistent operation and long-term reliability.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM601
Model # S46ER1
Barcode # BM601
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 330.0
Spring Rate Standard 52.0 N/mm
Type Code S46ER1
Stroke Metal to Metal (mm) 78.0
Product Family STX 46 Street
Notes Front
Fitted Spring 01096-10
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category