The Ohlins STX 46 Street rear shock for BMW R 1100 R and R 850 R is built to deliver controlled, consistent damping for road riding. It uses a monotube design intended to improve rear-wheel contact and chassis stability as conditions change. This unit is suited to riders who want a more precise, tuneable feel without compromising everyday usability.

Ohlins | Made to race, perfected to ride

Ohlins street shocks draw on the same engineering approach used in competition, then refined for real-world ride quality and durability. The focus is predictable behaviour through the stroke and clear feedback at the tyre. The result is suspension you can set up to suit your pace and your roads.

Shock design & features

This is an STX monotube rear shock with separated oil and gas to help maintain damping consistency over longer rides. The internal layout is designed to keep the oil stable and reduce performance drop-off as temperatures rise. It is supplied with a fitted spring matched for the intended application.

Tuning controls

The shock includes rebound damping adjustment to tailor how quickly the rear recovers after bumps and load changes. It also features a hydraulic spring preload adjuster for convenient ride-height and load compensation when switching between solo, luggage, or pillion use. These adjustments allow you to balance comfort, grip, and stability to your preference.

Base setup (factory preset)

Ohlins shocks are delivered with a baseline setting intended to work across typical street conditions. Use this as your reference point, then make small changes and test one adjustment at a time. If you are changing load often, start by setting preload correctly before refining rebound.

Before you install

Confirm fitment for your exact model and year, and inspect linkage bearings and mounting hardware for wear before installation. After fitting, check sag and ensure there is adequate clearance through suspension travel. A professional setup can help you get the most from the adjusters with minimal trial and error.

Serviceability/lifecycle

This Ohlins unit is fully serviceable and intended to be maintained over its life. Periodic servicing helps keep damping performance consistent and protects internal components from wear. Service intervals depend on use, riding conditions, and storage.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM635
Model # S46DR1LS
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 358.0 +10/-2
Spring Rate Standard 180.0 N/mm
Type Code S46DR1LS
Stroke Metal to Metal (mm) 57.0
Product Family STX 46 Street
Fitted Spring 01093-74
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category