The Ohlins STX 46 Supersport rear shock for the Ducati 999 Biposto is built to deliver stable damping control and clear chassis feedback for sporty road and track riding. Based on Ohlins racing development, it is intended to keep the rear tyre working consistently through braking, turn-in and acceleration. This unit uses a gas-pressurised design to help maintain damping consistency during demanding use.

Ohlins | Made to race, perfected to ride

Ohlins Supersport shocks are developed with a focus on predictable damping behaviour and repeatable setup changes. The STX platform is widely used for performance road and track applications where rider feel and stability matter.

Shock design & features

  • STX 46 Supersport architecture with gas-pressurised damping for consistent performance.
  • Mono rear shock configuration suited to the Ducati 999 Biposto rear suspension layout.
  • Built around independent damping circuits to support controlled weight transfer and traction management.

Tuning controls

This rear shock provides external adjustment for rebound damping and compression damping, allowing you to fine-tune the bike’s response for different tyres, surfaces and riding intensity. Preload is adjustable to set ride height balance and match the fitted spring to rider load.

Base setup (factory preset)

Ohlins supplies this unit with a factory baseline aimed at a well-rounded starting point for sporty riding. From there, damping and preload can be refined to suit rider preference, tyre choice and typical conditions.

Before you install

  • Confirm fitment for Ducati 999 Biposto and check clearance around the linkage and exhaust.
  • Set sag and preload first, then adjust rebound and compression in small steps to establish balance.
  • If you change tyres or ride conditions, revisit your settings to maintain stability and grip.

Serviceability/lifecycle

As with any high-performance shock, regular servicing helps maintain damping consistency and component life. Service intervals depend on use, especially if the bike sees frequent track days.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU138
Model # S46PR1C1
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 305.0
Spring Rate Standard 75.0 N/mm
Type Code S46PR1C1
Stroke Metal to Metal (mm) 71.0
Product Family STX 46 Supersport
Fitted Spring 01091-21
Spring Colour Yellow
Rec. Ohlins Oil 01309-

More From This Category