The Ohlins DU935 is a rear TTX RT shock developed for the Ducati Panigale Superleggera. It uses a gas-pressurised damping system to help maintain consistent control as conditions and temperatures change. Independent compression and rebound circuits allow you to tailor feel and grip to your riding and set-up approach.

Ohlins | Made to race, perfected to ride

Built around Ohlins TTX architecture, this unit is intended to deliver clear feedback and stable chassis behaviour under demanding use. The damping layout is designed to separate the damping functions for more predictable response when you make adjustments.

Who this shock is for

Suited to riders focused on improving rear-end control, traction and confidence on a Panigale Superleggera. It’s a good match when you want a purpose-built rear mono shock with proper adjustment range for set-up work.

Shock design & features

This is a gas-pressurised shock with oil and gas separation to support consistent damping performance. The TTX RT family is based on race-derived internal architecture aimed at maintaining composure through braking, turn-in and corner exit.

Tuning controls

  • Rebound damping adjustment for controlling return speed and stability
  • Compression damping adjustment for managing support and impact control

Before you install

Confirm fitment for your exact Ducati model and any existing ride-height or linkage changes. After installation, plan on setting sag and then using small damping changes to dial in balance with your tyres and riding conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU935
Model # T36PR1C1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Type Code T36PR1C1L
Stroke Metal to Metal (mm) 65.0
Product Family TTX RT

More From This Category