The Ohlins DU701 STX 46 Adventure rear shock is built for consistent damping control and stability on Ducati ST 2, ST 3 and ST 4 models. It is suited to riders who cover mixed surfaces and want a composed rear end when conditions change. Designed for adventure and touring use, it helps the bike track cleanly over rough and uneven roads.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on control, traction and predictable feedback. This unit is part of the STX 46 Adventure family, intended for real-world durability and ride quality across long distances.

Who this shock is for

  • Adventure and touring riders who want stable, confidence-building rear suspension behaviour
  • Owners carrying luggage or a pillion who need extra support and adjustability
  • Riders looking for a serviceable, performance-focused replacement rear shock

Shock design & features

This is an oil/gas separated monotube shock design, aimed at maintaining damping consistency as conditions vary. The STX architecture is intended to provide controlled movement through the stroke and improved chassis stability on rougher surfaces.

Tuning controls

The DU701 includes external adjusters for rebound damping and compression damping, allowing practical tuning for load, surface and riding pace without dismantling the shock.

Before you install

Confirm fitment for your specific Ducati ST 2, ST 3 or ST 4 variant and check surrounding clearance, linkage condition and bearings before installation. After fitting, set sag and then fine-tune rebound and compression to match your typical load and roads.

Serviceability/lifecycle

As a serviceable Ohlins unit, this shock can be maintained with periodic oil and seal service to keep performance consistent over time. Regular inspection is recommended if the bike sees frequent rough-road or all-weather use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU DU701
Model # S46HR1C1S
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 305.0
Spring Rate Standard 95.0 N/mm
Type Code S46HR1C1S
Stroke Metal to Metal (mm) 63.0
Product Family STX 46 Adventure
Fitted Spring 01091-31

More From This Category