The Ohlins FGR175 complete front fork assembly is built to deliver consistent damping control and clear front-end feedback on the Triumph Daytona 675R. It is designed to improve stability under braking and maintain composure through corner entry and mid-corner loads. Adjustment is provided to help you tune the feel to your riding conditions and preference.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience, the FGR175 is intended for riders who want a more controlled and communicative front end. It focuses on damping precision and repeatability so the bike remains predictable as conditions change.

Who this fork is for

  • Triumph Daytona 675R riders chasing improved braking support and cornering confidence
  • Riders who want more front-end feel without sacrificing everyday ride quality
  • Road and track-day use where consistent damping response matters

Shock design & features

  • Complete front fork unit designed for the Daytona 675R fitment
  • Premium internal components aimed at durability and consistent performance
  • Damping characteristics focused on stability, support, and feedback

Tuning controls

  • Compression adjustment
  • Rebound adjustment

Before you install

  • Confirm model and variant compatibility before fitting
  • Set sag and adjust damping methodically, changing one setting at a time
  • Have installation carried out by a qualified technician if you are unsure

Serviceability/lifecycle

Ohlins units are designed to be serviced to keep damping performance consistent over time. Regular inspection and periodic servicing will help maintain feel, control, and reliability.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FGR175
Model # TTX25G
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Type Code TTX25G
Fork Length (mm) 743.0
Stroke Metal to Metal (mm) 120.0
Product Family FGR 100
Notes *Replaced by FKR 120* Springs -90,-95,-10 included in kit

More From This Category