The Ohlins FKR128 FKR 100 fork cartridge front is designed to improve front-end control and rider confidence on the Triumph Street Triple RS. It focuses on refined damping behaviour to support braking stability and clearer feedback through the bars. The result is a more composed feel for spirited road riding with the adjustability needed for occasional track use.

Ohlins | Made to race, perfected to ride

Developed with Ohlins cartridge technology, this kit is intended to sharpen steering response and give a more communicative front end without compromising ride quality. It is built around premium internal components for consistent damping performance.

Who this cartridge kit is for

  • Triumph Street Triple RS riders chasing improved braking stability and front-end feel
  • Spirited street riders who want more control and confidence
  • Riders doing occasional track days who need easy, repeatable adjustability

Shock design & features

  • Front fork cartridge kit designed to enhance mid-corner feel and stability
  • Premium internal components to support consistent damping performance
  • Engineered to deliver a composed, communicative front end

Tuning controls

  • Separate compression adjustment for fine tuning
  • Separate rebound adjustment for fine tuning

Is it right for you?

If your priority is clearer feedback, improved braking stability and a more controlled front end on a Street Triple RS, the FKR128 FKR 100 cartridge kit fits that brief. If you primarily ride at a relaxed pace and are satisfied with your current fork behaviour, you may not need the extra adjustability this kit provides.

Before you install

This product is a front fork cartridge kit intended for the Triumph Street Triple RS. Ensure your workshop follows correct procedures for cartridge installation and setup so the adjustment range and damping characteristics can be fully utilised.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU FKR128
Model # TTX25S
Barcode # FKR128
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.200 x 0.200 x 0.800m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Front cartridge
Type Code TTX25S
Fork Length (mm) 732.0
Stroke Metal to Metal (mm) 120.0
Product Family FKR 100
Notes Comes with 3 different spring rates: 9, 9.5 & 10N/mm
Fitted Spring Sold separately. See notes.
Rec. Ohlins Oil 01309-

More From This Category