The Ohlins HD244 STX 36 twin rear shock set is built to improve damping control and chassis feel on Harley-Davidson Sportster models. Designed as a matched pair for twin-shock rear ends, it focuses on consistent response and tunability for real-world road use. The STX 36 platform is intended for riders who want clearer feedback without compromising day-to-day ride quality.

Ohlins | Made to race, perfected to ride

Ohlins development is grounded in repeatable damping control and predictable behaviour over a wide range of conditions. This twin-shock configuration targets stability and traction with a measured, engineering-led approach to suspension performance.

Who this shock is for

  • Sportster riders wanting more support and control from the rear end
  • Owners who prefer a tunable setup for changing loads and road conditions
  • Riders looking to refresh ageing or inconsistent rear suspension with a quality matched pair

Shock design & features

This is a gas-pressurised design to help keep damping consistent through longer or harder rides. As a twin-shock rear arrangement, the pair works together to manage rear wheel control and chassis attitude, with the STX 36 architecture aimed at stable, repeatable damping response.

Tuning controls

The HD244 provides external adjustment for rebound damping and compression damping, allowing you to balance comfort, support and traction to suit your riding style. Spring preload adjustment is also used to set ride height and suit rider and luggage load.

Before you install

  • Confirm your motorcycle uses a rear twin-shock layout and that the mounting points match your Sportster configuration
  • Set sag and preload first, then fine-tune rebound and compression to suit your roads
  • Check clearance around belt/chain, guards and exhaust components through full suspension travel

Serviceability/lifecycle

Ohlins shocks are designed to be maintained. Periodic servicing helps keep damping consistent and protects internal components over time, particularly if the bike is ridden regularly or in harsh conditions.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD244
Model # S36PR1C1LB
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 360.0 +10/-0
Spring Rate Standard 15.0 - 24.0 N/mm Progressive
Type Code S36PR1C1LB
Stroke Metal to Metal (mm) 101.0
Product Family STX 36 Twin
Fitted Spring 00480-01
Spring Colour Black

More From This Category