The Ohlins STX 36 Blackline rear shock pair for Harley-Davidson FL Touring models is built to improve damping control and ride stability while keeping a classic, understated look. Designed for twin-shock applications, it suits riders chasing a more planted feel over varied road surfaces without compromising the bike’s character. This unit uses a monotube architecture with separated oil and gas for consistent damping behaviour.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on controlled wheel movement, predictable feedback and repeatable performance. The Blackline finish is intended to suit custom and heritage styling while retaining modern internal damping design.

Who this shock is for

Suited to FL Touring riders who want improved comfort and chassis control in real-world road use, including heavier touring setups and long days in the saddle. Also a strong match for custom builds where appearance matters as much as function.

Shock design & features

This is an STX 36 twin rear shock set with a monotube layout and separated oil and gas to help maintain damping consistency. The design is intended to manage heat and aeration more effectively than simpler emulsion-style shocks, supporting stable behaviour over changing conditions.

Tuning controls

You can tune spring preload and rebound damping to match load, riding style and road conditions. These adjustments are aimed at balancing comfort, ride height behaviour and control through corners and bumps.

Before you install

  • Confirm fitment for your exact Harley-Davidson FL Touring model and year before installation.
  • Set sag and preload for your typical riding load, then fine-tune rebound to control return speed after bumps.
  • Installation should be performed by a qualified technician if you are not experienced with suspension work.

Serviceability/lifecycle

Ohlins shocks are designed to be serviceable, supporting long-term performance with periodic maintenance. Regular servicing helps keep damping consistent and internal wear under control over the life of the unit.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD773
Model # S36D (B)
Barcode # HD773
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 329.0 / 12.9"
Spring Rate Standard 25.0 N/mm
Type Code S36D (B)
Stroke Metal to Metal (mm) 92.0 / 3.6"
Product Family STX 36 Blackline
Fitted Spring 00281-68
Spring Colour Black
Rec. Ohlins Oil 01309-

More From This Category