The Ohlins HD716 STX 36 Twin is a rear twin-shock unit developed for Harley-Davidson Sportster XL models where controlled damping and consistent feel matter. Built around Ohlins’ proven twin-shock architecture, it is designed to improve chassis stability and feedback across a wide range of road conditions. This unit uses a gas-pressurised damping system to help maintain consistent performance during extended riding.

Ohlins | Made to race, perfected to ride

Ohlins suspension is engineered with a focus on predictable damping behaviour and tuning range. The HD716 is part of the STX 36 Twin family, intended for riders who want a more controlled and confidence-inspiring rear end without compromising everyday usability.

Who this shock is for

  • Sportster XL riders wanting improved stability and traction from the rear suspension
  • Owners chasing clearer chassis feedback during cornering and braking
  • Riders who value adjustability to suit load, road surfaces, and riding style

Shock design & features

  • STX 36 twin-shock rear configuration
  • Gas-pressurised damping system to help reduce fade and maintain consistency
  • Designed to deliver sharper response and improved control at the rear tyre

Tuning controls

This unit provides external damping adjustment for both compression and rebound, allowing you to balance support, grip, and ride comfort to suit your setup and conditions.

Before you install

  • Confirm fitment for your exact Harley-Davidson Sportster XL variant and year
  • Set sag and verify spring suitability for your rider weight and typical load
  • Record your baseline settings before making tuning changes

Serviceability/lifecycle

Like other Ohlins units, the HD716 is intended to be maintained with periodic servicing to keep damping performance consistent over time, especially if the bike sees frequent or demanding use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HD716
Model # S36E
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Twin
Shock Length Eye to Eye (mm) 338.0
Spring Rate Standard 16.0 - 26.0 N/mm Progressive
Type Code S36E
Stroke Metal to Metal (mm) 103.0
Product Family STX 36 Twin
Fitted Spring 21211-02 (C)

More From This Category