The Ohlins STX 46 Adventure rear shock for the Highland 900 is built for riders who need predictable damping and stability across mixed surfaces. It is designed to maintain control over rough tracks while supporting real-world loads such as luggage or a passenger. This unit uses a separated oil and gas design to help keep damping consistent as conditions change.

Ohlins | Made to race, perfected to ride

Developed from Ohlins racing experience and adapted for adventure and touring use, this shock is intended to deliver controlled wheel movement and a composed chassis feel. The focus is on usable traction, comfort and confidence rather than harshness.

Who this shock is for

  • Highland 900 riders covering long distances on sealed roads, gravel and uneven terrain
  • Riders who regularly vary load with luggage and/or a pillion and want suspension that can be tuned to suit
  • Owners looking for a rebuildable, serviceable rear shock solution

Shock design & features

This is an Ohlins STX 46 Adventure series rear mono shock. The internal architecture separates oil and gas to better manage heat and reduce damping fade during extended, rough riding. The construction is aimed at durability and consistent performance in demanding conditions.

Tuning controls

The shock includes external damping adjustments for both compression and rebound, allowing you to adapt the feel for terrain, pace and load. It also includes a remote hydraulic spring preload adjuster to set sag quickly when adding or removing luggage or a passenger.

Before you install

  • Confirm fitment for the Highland 900 rear mono position before installation
  • This unit is supplied with an Ohlins spring fitted (part number 00698-21)
  • After installation, set rider sag and then fine-tune rebound and compression based on grip, comfort and control

Serviceability / lifecycle

Like other Ohlins units, this shock is intended to be serviced to maintain performance over time. Regular inspection and periodic servicing help keep damping consistent, particularly for frequent off-road or heavily loaded use.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HI488
Model # S46PR1C2
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 379.0
Shock Length Eye to Eye (mm) 379
Spring Rate Standard 75.0 N/mm
Type Code S46PR1C2
Stroke Metal to Metal (mm) 101.0
Product Family STX 46 Adventure
Fitted Spring 00698-21

More From This Category