The Ohlins STX 46 Adventure rear shock for the BMW R 1100 RT is built for consistent damping control across long-distance touring and mixed-surface riding. It is designed to maintain stability and comfort when conditions change, including rough roads and loaded travel. The construction prioritises durability and predictable response rather than a harsh, over-sprung feel.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed with a focus on repeatable performance and tunability. This unit is aimed at riders who want a more controlled rear end and the ability to fine-tune feel for different loads and road surfaces.

Shock design & features

This is an STX 46 Adventure-series rear mono shock with oil and gas separated to help maintain damping consistency on long rides. The layout is intended to manage heat and reduce fade during extended use on uneven surfaces.

Tuning controls

Adjustability includes rebound damping control and a hydraulic spring preload adjuster for quick changes when adding luggage or carrying a passenger. These controls are intended to make setup changes practical without removing the shock.

Base setup (factory preset)

The shock is supplied with a factory baseline setting suitable as a starting point for the BMW R 1100 RT. Fine-tuning should be based on rider weight, typical load, and the type of roads you ride most often.

Before you install

  • Confirm the bike model and year compatibility for BMW R 1100 RT before fitting.
  • Set sag and preload first, then use rebound adjustment to control return speed and ride feel.
  • If fitting with luggage or a pillion, re-check preload and handling balance after loading the bike.

Serviceability/lifecycle

This Ohlins rear shock is rebuildable and intended to be serviced to maintain performance over time. Service intervals depend on usage conditions, with more frequent attention recommended for harsh or high-mileage adventure touring.

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU BM055
Model # S46DR1L
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 358.0 +10/-2
Spring Rate Standard 200.0 N/mm
Type Code S46DR1L
Stroke Metal to Metal (mm) 57.0
Product Family STX 46 Adventure
Notes Type S46DR1L
Fitted Spring 01093-84

More From This Category