The Ohlins HO324 STX 36 Scooter rear shock is built for the Honda MSX 125 (Grom) as a dedicated replacement unit. It uses a gas-pressurised design to help maintain consistent damping during repeated hits and sustained riding. With external adjusters for both compression and rebound, it allows practical tuning for different roads, loads and rider preferences.

Ohlins | Made to race, perfected to ride

Ohlins suspension is developed from long-term motorsport experience and applied to real-world motorcycles and scooters. The STX 36 Scooter range focuses on controlled damping, stable chassis behaviour and repeatable adjustment.

Who this shock is for

  • Honda MSX 125 (Grom) riders looking to improve rear-end control and stability
  • Owners wanting more adjustability than a standard rear mono shock
  • Riders who value consistent damping from a gas-pressurised shock design

Shock design & features

  • STX 36 Scooter rear mono shock architecture
  • Gas-pressurised damping design to support consistent performance
  • Independent damping circuits intended for more controlled response

Tuning controls

  • Compression damping adjustment
  • Rebound damping adjustment

Before you install

  • Confirm fitment for Honda MSX 125 (Grom) and rear mono shock application
  • Use the supplied fitted spring and note that optional springs may be available
  • After installation, set sag and then fine-tune compression and rebound to suit your riding

Öhlins Motorcycle Suspension Warranty

New Öhlins motorcycle shock absorbers, front forks and cartridge kits supplied by Teknik Motorsport are covered by the applicable Öhlins manufacturer’s warranty against defects in materials and workmanship.

Teknik Motorsport is an authorised Öhlins Service Centre and administers warranty claims in accordance with the Öhlins warranty conditions. The service intervals below form part of the maintenance requirements for Öhlins products supplied and supported by Teknik Motorsport.

This warranty is in addition to the consumer guarantees that apply under the Australian Consumer Law.

  • Registered motorcycles — non-competition road use Five years, subject to correct application, installation, setup and servicing every: 20,000 km or two years, whichever occurs first.
  • Registered motorcycles — adventure and light off-road use Five years, subject to correct application, spring rate, setup and servicing every: 10,000 km or annually, whichever occurs first.
  • Unregistered or competition motorcycles Two years for eligible Öhlins MX and Enduro products, subject to inspection every ten hours and servicing every: 30 operating hours or annually, whichever occurs first.

Compliance with the applicable service interval is a condition of the Öhlins manufacturer’s warranty. Evidence of servicing may be required when a warranty claim is assessed.

A seal leak, loss of damping performance or internal wear arising after the prescribed service interval has been exceeded will be treated as a service or maintenance issue rather than a manufacturing defect.

Warranty repairs

Öhlins suspension products are designed to be serviced and repaired. Where a warranty claim is approved, the normal remedy is repair of the customer’s original suspension unit using genuine Öhlins replacement parts.

Replacement of a complete shock absorber, fork or cartridge kit is not automatic and would normally occur only where the product has suffered a manufacturing failure that cannot reasonably be repaired. This is at Ohlins discretion. 

Öhlins spare parts and service kits

Öhlins spare parts, seals, bushes, service kits, springs, fluids and individual components are covered only against defects present when supplied.

No fixed age-based warranty applies to wear items, service parts or consumable components. Wear, deterioration, contamination, incorrect installation and damage caused by another component are not manufacturing defects.

Öhlins gives the customer a meaningful five-year warranty on products (Units), provided the suspension is maintained as suspension should be maintained. Teknik supports that warranty locally, can inspect the product properly, and can repair it with genuine parts rather than discarding it.

SKU HO324
Model # S36PC1
Barcode # HO324
Brand Ohlins
Shipping Weight 5.0000kg
Shipping Size 0.300 x 0.300 x 0.500m
Type Units
See our Shipping Information See our Frequently Asked Questions
Position (Front or Rear) Rear Mono
Shock Length Eye to Eye (mm) 244.0
Spring Rate Standard 80.0 N/mm
Spring Rate TBA
Type Code S36PC1
Stroke Metal to Metal (mm) 40.0
Product Family STX 36 Scooter
Notes Optional spring 60281-08/100N/mm, repl.by HO 424
Fitted Spring 60281-07
Spring Colour Yellow

More From This Category